Parachute Ping-Pong Slingshot Molded in TinkerCAD!
by supercowbaby123 in Craft > Duct Tape
371 Views, 0 Favorites, 0 Comments
Parachute Ping-Pong Slingshot Molded in TinkerCAD!
.png)
View Tinkercad link here:
https://drive.google.com/drive/folders/1vC7F3vYEAlPcMwutj5sZ-wRRTL0xGW7E?usp=sharing
Making the Hole

Make a hole in your ping-pong ball.
Cutting Off the Zipper

Cut the zipper off your plastic bag.
Taping the Thread

Tape 4 pieces of thread to your plastic bag.
Taping the Hole.

Put the thread in the hole we made in step 1 and seal with a piece of duct tape.
Gathering and Covering 4 Popsicle Sticks


Make 2 stacks of 2 popsicle sticks, and cover with duct tape.
Arranging and Placing


Arrange popsicle sticks in a V shape and place popsicle stick 1 3/4 inch from the bottom.
Measuring and Cutting


Draw 2 lines as shown on the image above and cut on the lines.
Cutting


Cut on lines and cover with duct tape
Putting in Screws

Put 2 screws and bolts in the popsicle sticks.
Making the Handle


Gather 6 popsicle sticks and cover with duct tape.
Screwing in Place

Screw handle in place.
Tying the Rubber Bands

Tie 2 rubber bands to the slingshot as shown.
Enjoy!
Enjoy your new slingshot!